2019-09-04

Front door locks, at last

Even though I have had electronic door locks for something like 30 years, since well before I was married, my wife, for some reason, wanted a "normal" front door for the house. First units were made from a cassette player head (Sony Walkman, I think) and read mag cards (bank cards).

This is crazy (IMHO, but obviously I am "wrong"). For a long time it was a typical double glazing unit, but she then got a custom made wooden door. Nice!

Even though custom made, she was not keen on me insisting on electronic locks. I am not sure why.

Anyway, I did manage to get good euro profile actual locks, hard to pick, etc, and you need a 3D printer to make a fake key! Yeh, I know!!

The problem is we got some keys, and could get more, but with 5 kids and their various family you run out, especially if any are staying with you or visiting enough to have a key.

The end result was rather annoying for me. In practice the house is never empty, but having a key in a box outside the door is not a good security measure! Not quite a key under the mat, but damn close!

So finally I got a locking spindle.

I fitted it and routed wires in the mechanism to the hinge, etc.

The mechanical lock still works, obviously.

Unless deadlocked (as I say, never nobody here), the door can be opened by using the handle inside. Yes, that too is multi-point locking, but you just turn the handle.

Now the outside handle also works, if 12V is applied to the locking spindle. Suitable amounts of super glue, etc, make it hard to dismantle and operate otherwise. The door supplier has just used a split spindle which could easily be opened with a screw driver and replaced - crazy!

But this little device was simple, and around £60. There are options for a completely new multi-point locking strip with motors in it, but they are a lot more work and cost. This was surprisingly simple.

I already had a card reader on the wall near the front door, now an NFC reader using an ESP32 (inside) to check cards. That simply set the alarm, previously, but now can be used to "engage" the locking spindle.

End result is that I can now easily allow some access at some times of day, using DESFire cards, or even just bank cards, if and when I like, and no keys in a box outside. We have someone staying with us for a few days, and they were suitably gobsmacked that I just enabled their bank card to work the front door for a few days!

I am surprised more locks are not like this to be honest. The tech is way better now, but still, it has always been so much better than simple mechanical keys.

6 comments:

  1. Replies
    1. https://www.locksonline.co.uk/Electric-Locking-Spindle.html

      Delete
  2. I considered this sort of thing for a while, but I don't have enough confidence in my own work to be sure it won't go wrong -- and if it fails closed I'm locked out, and if it fails open I'm in almost as much trouble. And what happens if the power goes out, or even flickers? I can open a normal key-locked door no matter what.

    (Also... what do insurance companies think about locks like this, particularly roll-yer-own ones? I can't imagine they are especially happy.)

    Normal locks suck but they suck worse than either failure mode above.

    ReplyDelete
    Replies
    1. I can’t imagine insurance companies would accept this. They’re fussy enough over “regular” locks.

      Delete
  3. What euro cylinders were you using before? (Assuming you don't mind sharing, totally get it if you don't want to answer that)

    Were moving house so am in the market for new locks. Currently have mul-t-locks and will use the same unless someone has a better suggestion 🙂

    ReplyDelete
    Replies
    1. https://www.revk.uk/2013/12/abs-lock-vs-3d-printer.html

      Delete

Comments are moderated purely to filter out obvious spam, but it means they may not show immediately.

Fencing

Bit of fun... We usually put up some Christmas lights on the house - some fairy lights on the metal fencing at the front, but a pain as mean...